Robopac Compacta S9 - Product Dimensions

ENG
TECHNICAL INFORMATION
40
3.7.1. PRODUCT DIMENSIONS
The dimensions (width and height) of the product sections that can be processed must be kept within the limits marked
on the chart. The above-mentioned data are valid when the section is uniform for the whole length of the product.
For best quality results, the product cross section should be as close as possible to the machine diameter.
For products that intersect the hatched areas, contact the Manufacturer.
Machine
Spool
Minimum size of product that can be processed (mm)
Compacta S4
125
50 x 50 x 450
Compacta S6
125
70 x 70 x 450
Compacta S9
125
90 x 90 x 450
Compacta S9
250
90 x 90 x 600
Compacta S12
125/250
150 x 150 x 600