The parameters of the wrapping cycle are the following:
B1) Number of wrappings (varying from 1 to 9).
It allows you to set the number of additional wraps to
be carried out at the beginning of the wrapping cycle
(product head).
B2) Number of wrappings (varying from 1 to 9).
It allows you to set the number of additional wraps
that must be carried out at the centre of the product.
B3) Number of wrappings (varying from 1 to 9).
It allows you to set the number of additional wraps
that must be carried out at the end of the wrapping
(product tail).
C) Product wrapping cycles.
-
“TOTAL” wrapping.
The product is completely spiral wrapped with
additional wraps on head and tail.
-
“Head - tail” wrapping.
The product is only wrapped at the head and tail.
-
“Total”
and
“central bands” wrapping.
The product is completely wrapped in a spiral, with
additional wraps on head and tail, and with a series
of reinforcing wrappings spaced using a settable
time.
-
“Head-tail”
and
“central bands” wrapping.
The product head and tail are wrapped with a series
of reinforcing wrappings spaced using a settable
time.
-
“Head
and
additional bands” wrapping (Optional).
The product is wrapped at the head and with a series
of additional reinforcing wrappings in quantities and
distances that can be set through the corresponding
parameters.
“Bypass” cycle.
The product passes through the machine without
being wrapped.
To Next Page
Loading...
