Rockwell Automation Publication ICSTT-RM447M-EN-P - July 2019 101
Specifying a New Controller Chapter 6
Safety Related System Installation Process
For a Safety Related System the installation process must also be in line with
the following:
Specifying an Enclosure
When the system is installed in an enclosure it must meet the UL508
requirements for the installation environment; hold the modules securely,
provide mechanical protection and should not interfere with other system
components. The enclosure must also be able to handle the heat dissipated by
the modules and other components/devices included in the same enclosure.
WARNING: You must use the installation guidelines given in this manual
and any installation and commissioning procedures that comply with
applicable international or local codes and standards.
ATTENTION: AADvance modules are suitable for use in Class I, Division 2,
Groups A, B, C and D Hazardous locations or Non-hazardous locations only or
equivalent.
ATTENTION: Pour les modules AADvance sont utilisables dans Class I,
Division 2, A, B, C et D pour un environnement dangereux ou pour un
environnement non dangereux ou équivalente
To Next Page
Loading...
Need help?
General
