Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
293User Manual 1173.9240.02 ─ 17
Parameters:
<Separator> COMMa
Uses a comma as decimal separator, e.g. 4,05.
POINt
Uses a point as decimal separator, e.g. 4.05.
*RST: *RST has no effect on the decimal separator.
Default is POINt.
Example:
FORM:DEXP:DSEP POIN
Sets the decimal point as separator.
Manual operation: See "Decimal Separator" on page 134
See "Exporting the Peak List" on page 147
FORMat:
DEXPort:HEADer <State>
If enabled, additional instrument and measurement settings are included in the header
of the export file for result data. If disabled, only the pure result data from the selected
traces and tables is exported.
See chapter 11.7.5, "Reference: ASCII File Export Format", on page 297 for details.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Usage: SCPI confirmed
Manual operation: See "Include Instrument Measurement Settings" on page 133
FORMat:DEXPort:TRACes <Selection>
This command selects the data to be included in a data export file (see MMEMory:
STORe<n>:TRACe on page 292).
Parameters:
<Selection> SINGle
Only a single trace is selected for export, namely the one speci-
fied by the MMEMory:STORe<n>:TRACe command.
ALL
Selects all active traces and result tables (e.g. Result Summary,
marker peak list etc.) in the current application for export to an
ASCII file.
The <trace> parameter for the MMEMory:STORe<n>:TRACe
command is ignored.
*RST: SINGle
Usage: SCPI confirmed
Manual operation: See "Export all Traces and all Table Results" on page 133
Retrieving Results
To Next Page
Loading...
