Rohde & Schwarz FSW Series - Page 78

Configuration
R&S
®
FSW-K7
78User Manual 1173.9240.02 ─ 17
For more information on coupling frequencies and reverse sweeps see chapter 4.7.4.7,
"Coupling the Frequencies", on page 43. For more information on error messages and
the channel bar see chapter 4.7.4.8, "Displayed Information and Errors", on page 46.
Remote command:
SOURce:EXTernal:FREQuency[:FACTor]:DENominator on page 220
SOURce:EXTernal:FREQuency[:FACTor]:NUMerator on page 221
SOURce:EXTernal:FREQuency:OFFSet on page 221
Result Frequency Start
For reference only: The start frequency for the generator, calculated from the config-
ured generator frequency and the start value defined for the R&S FSW.
Result Frequency Stop
For reference only: The stop frequency for the generator, calculated from the config-
ured generator frequency and the stop value defined for the R&S FSW.
Source Calibration Functions
The calibration functions of the external generator are available in the "Source Calibra-
tion" subtab of the "External Generator" tab, but only if external generator control is
active (see "Source State" on page 76).
Calibrate Transmission................................................................................................. 79
Calibrate Reflection Short............................................................................................. 79
Calibrate Reflection Open.............................................................................................79
Source Calibration Normalize....................................................................................... 79
Recall............................................................................................................................ 79
Save As Trd Factor....................................................................................................... 80
Reference Position........................................................................................................80
Reference Value........................................................................................................... 80
Input and Frontend Settings