Rohde & Schwarz FSW Series - Page 76

Configuration
R&S
®
FSW-K7
76User Manual 1173.9240.02 ─ 17
Source State................................................................................................................. 76
Source Power................................................................................................................76
Source Offset................................................................................................................ 76
Source Frequency Coupling..........................................................................................77
(Manual) Source Frequency..........................................................................................77
(Automatic) Source Frequency (Numerator/Denominator/Offset).................................77
Result Frequency Start................................................................................................. 78
Result Frequency Stop..................................................................................................78
Source State
Activates or deactivates control of an external generator.
Remote command:
SOURce:EXTernal[:STATe] on page 222
Source Power
The output power of the external generator. The default output power is -20 dBm. The
range is specified in the data sheet.
Remote command:
SOURce:EXTernal:POWer[:LEVel] on page 222
Source Offset
Constant level offset for the external generator. Values from -200 dB to +200 dB in 1
dB steps are allowed. The default setting is 0 dB. Offsets are indicated by the "LVL"
label in the channel bar (see also chapter 4.7.4.8, "Displayed Information and Errors",
on page 46).
Input and Frontend Settings