Rohde & Schwarz FSW Series - Page 75

Configuration
R&S
®
FSW-K7
75User Manual 1173.9240.02 ─ 17
TTL Handshake
If available for the specified generator type, this option activates TTL synchronization
via handshake for GPIB connections.
Using the TTL interface allows for considerably higher measurement rates than pure
GPIB control, because the frequency stepping of the R&S FSW is directly coupled with
the frequency stepping of the generator.
For more information on TTL synchronization see "TTL synchronization" on page 45.
For an overview of which generators support TTL synchronization see chapter 4.7.4.2,
"Overview of Generators Supported by the R&S FSW-B10 Option", on page 38.
Remote command:
SYSTem:COMMunicate:RDEVice:GENerator:LINK on page 224
GPIB Address / TCP/IP Address
For LAN connections: TCP/IP address of the signal generator
For GPIB connections: GPIB address of the signal generator.
Remote command:
SYSTem:COMMunicate:GPIB:RDEVice:GENerator:ADDRess on page 223
SYSTem:COMMunicate:TCPip:RDEVice:GENerator:ADDRess on page 224
Reference
Selects the internal R&S FSW or an external frequency reference to synchronize the
R&S FSW with the generator (default: internal).
Remote command:
SOURce:EXTernal:ROSCillator[:SOURce] on page 223
Edit Generator Setup File
Displays the setup file for the currently selected Generator Type in read-only mode in
an editor.
Although the existing setup files are displayed in read-only mode in the editor, they can
be saved under a different name (using "File > SaveAs").
Be careful, however, to adhere to the required syntax and commands. Errors will only
be detected and displayed when you try to use the new generator (see also chap-
ter 4.7.4.8, "Displayed Information and Errors", on page 46).
For details see chapter 4.7.4.3, "Generator Setup Files", on page 40.
Frequency Min. / Frequency Max.
For reference only: Lower and upper frequency limit for the generator.
Level Min. / Level Max.
For reference only: Lower and upper power limit for the generator.
Measurement Settings
The measurement settings for external generator control are configured in the "Mea-
surement Configuration" subtab of the "External Generator" tab.
Input and Frontend Settings