Rohde & Schwarz FSW Series - Page 74

Configuration
R&S
®
FSW-K7
74User Manual 1173.9240.02 ─ 17
● Interface Configuration Settings..............................................................................74
● Measurement Settings............................................................................................ 75
● Source Calibration Functions..................................................................................78
Interface Configuration Settings
The interface settings for the connection to the external generator are defined in the
"Interface Configuration" subtab of the "External Generator" tab.
For more information on configuring interfaces see the "Remote Control Interfaces and
Protocols" section in the R&S FSW User Manual.
Generator Type.............................................................................................................74
Interface........................................................................................................................ 74
TTL Handshake.............................................................................................................75
GPIB Address / TCP/IP Address...................................................................................75
Reference......................................................................................................................75
Edit Generator Setup File..............................................................................................75
Frequency Min. / Frequency Max..................................................................................75
Level Min. / Level Max.................................................................................................. 75
Generator Type
Selects the generator type and thus defines the generator setup file to use.
For an overview of supported generators see chapter 4.7.4.2, "Overview of Generators
Supported by the R&S FSW-B10 Option", on page 38. For information on generator
setup files see chapter 4.7.4.3, "Generator Setup Files", on page 40.
Remote command:
SYSTem:COMMunicate:RDEVice:GENerator:TYPE on page 224
Interface
Type of interface connection used. The following interfaces are currently supported:
●
GPIB
●
TCP/IP (not by all generators)
For details on which signal generators support which interfaces, see the documenta-
tion of the corresponding signal generator.
Remote command:
SYSTem:COMMunicate:RDEVice:GENerator:INTerface on page 223
Input and Frontend Settings