Remote Control - Commands
NRP2
280User Manual 1173.9140.02 ─ 07
[SENSe<[1]..4>]:SGAMma:CORRection:STATe <state>
Activates/deactivates the measured-value correction of the reflection coefficient effect
of the source gamma.
Parameters:
<state> ON | OFF
*
RST: depending on sensor
Usage: Setting only
[SENSe<[1]..4>]:STATistics:AVERage? <power_value>
Returns the average power value calculated during a statistics measurement (CCDF/
PDF).
Unit: DBM | W | DBUV
Parameters:
<power_value> float_value
Default unit: DBM
Usage: Query only
[SENSe<[1]..4>]:STATistics[:EXCLude]:MID:OFFSet[:TIME] <time_interval>
Together with SENS:
STAT:MID:
TIME, allows a time interval within the time window to
be blanked out; in this interval, the data for the statistics is collected.
SENS:STAT:MID:OFFS determines the distance from the start of the measurement to
the start of the interval to be blanked out (see also [SENSe<[1]..4>][:POWer]:
TGATe<[1]..4>[:EXCLude]:MID:OFFSet[:TIME] on page 274).
Parameters:
<time_interval> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit:
S
[SENSe<[1]..4>]:STATistics[:EXCLude]:MID:TIME <time_interval>
Together with SENS:STAT:MID:
OFFS, allows a time interval within the time window to
be blanked out; in this interval, the data for the statistics is collected.
SENS:STAT:MID:TIME determines the length of the interval to be blanked out (see
also [SENSe<[1]..4>][:POWer]:TGATe<[1]..4>[:EXCLude]:MID:TIME
on page 275).
Parameters:
<time_interval> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit:
S
SENSe (Sensor Commands)
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
