Getting Started
NRP2
48User Manual 1173.9140.02 ─ 07
The parameter "Dropout" helps to reliably detect the end of modulated-signal
bursts (e.g. NADC). With unmodulated pulses as in this case, it should be set to 0.
Fig. 2-39: Burst av result window
For a detailed description of burst av power measurement, see chapter 4.2.1.3, "Mea-
suring the average power of burst signals", on page 67.
The power of burst can be measured also by means of timegates (see chapter 4.2.1.5,
"Measuring the average power in gates", on page 71 and
chapter 4.5.4, "Gates dis-
play mode", on page 120). In contrast to the burst mode which automatically detects
the burst end, the length and position of the gate over time must be exactly defined.
Measuring average burst power (Burst Av mode)
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
