Manual Operation
NRP2
52User Manual 1173.9140.02 ─ 07
Sensor menu Windows menu Measurement
menu
File menu System menu
Sensor menu
All sensor settings can be made using the "Sensor" menu. The type and details of data
acquisition can be specified with this menu.
See
chapter 4.2, "Data acquisition and parameters", on page 64 for a detailed
description of the "Sensor" menu.
Windows menu
The "Windows" menu is used to configure windows and the result display in the win-
dows.
See chapter 4.3, "Displaying measurement results", on page 91 for a detailed
description of the "Windows" menu.
Measurement menu
The details of postprocessing are summarized in the "Measurement" menu.
See chapter 4.4, "Configuring measurements", on page 97 for a detailed description
of the "Measurement" menu.
File menu
The "File" menu is used to handle the setup memories, window names and display
information about errors.
See chapter 4.6, "Management of settings", on page 141 for a detailed description of
the "File" menu.
System menu
The "System" menu is used to handle general functions that are not specifically used
to perform measurements, i.e. to configure the remote interfaces and I/O sockets, to
provide information about the meter and the connected sensors, and to trigger test
measurements.
See chapter 4.7, "System settings", on page 145 for a detailed description.
Menu layout
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
