Contents
NRP2
4User Manual 1173.9140.02 ─ 07
4.5 Displaying traces...................................................................................................... 113
4.6 Management of settings
........................................................................................... 141
4.7 System settings.........................................................................................................145
4.8 Messages and alarms............................................................................................... 166
5 Remote Control Fundamentals.........................................................169
5.1 Differences between Remote Control and Manual Control...................................169
5.2 Connecting a Controller to the Base Unit...............................................................170
5.3 Switchover to Remote Control (REMOTE)..............................................................172
5.4 Return to Manual Operation (LOCAL)..................................................................... 172
5.5 Automatic Settings when Switching between Local and Remote........................173
5.6 Communication on Data Lines................................................................................ 173
5.7 Structure and Syntax of device-dependent Messages..........................................175
5.8 Device Model and Command Processing...............................................................183
5.9 Automatic Settings for Manual Selection of a Measurement Mode..................... 184
5.10 Correspondence between Remote Control and Manual Control..........................186
6 Remote Control - Commands........................................................... 193
6.1 Notation......................................................................................................................193
6.2 Common Commands to IEEE 488.2........................................................................ 194
6.3 Overview of SCPI Command Systems.................................................................... 206
6.4 High-Level Measurement Commands (CONFigure, MEASure, READ and FETCh)
.................................................................................................................................... 208
6.5 CALCulate (Configuration of Calculate Blocks).....................................................224
6.6 CALibration ...............................................................................................................237
6.7 DISPlay.......................................................................................................................238
6.8 FORMat...................................................................................................................... 248
6.9 MEMory...................................................................................................................... 249
6.10 OUTPut.......................................................................................................................255
6.11 SENSe (Sensor Commands).................................................................................... 260
6.12 SERVice..................................................................................................................... 293
6.13 STATus.......................................................................................................................296
6.14 SYSTem......................................................................................................................318
6.15 TRIGger...................................................................................................................... 328
6.16 UNIT............................................................................................................................335
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
