Command Reference
R&S
®
ZNB/ZNBT
1138User Manual 1173.9163.02 ─ 53
See Chapter 5.5.5.4, "Multiple Port Assignments", on page 172 for background infor-
mation.
Note:
Use [SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:COUNt? to get the
number of port assignments of the "current" calibration.
Suffix:
<Ch>
.
Channel number
Example: See Chapter 9.2.5.2, "MultiCal (with Calibration Unit)",
on page 1361
Usage: Query only
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:COUNt?
Returns the number of port assignments of the "current" calibration, i.e. the calibration
last created using [SENSe<Ch>:]CORRection:COLLect:AUTO:CONFigure.
This is particulary useful if the default port assignments were established using
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:DEFault.
See Chapter 5.5.5.4, "Multiple Port Assignments", on page 172 for background infor-
mation.
Note:
In MultiCal scenarios, use [SENSe<Ch>:]CORRection:COLLect:AUTO:
ASSignment:ALL:COUNt? to get the number of port assignments of all calibrations.
Suffix:
<Ch>
.
Channel number
Example: See [SENSe<Ch>:]CORRection:COLLect:AUTO:
ASSignment<Asg>:DEFine on page 1140
Usage: Query only
Manual operation: See "Port Assignment (manual) " on page 423
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:DEFault
<TestPort1>, <TestPort2>...
Creates the default port assignment(s) for the specified test ports.
The number of created assignments can be queried using the [SENSe<Ch>:
]CORRection:COLLect:AUTO:ASSignment:COUNt? command.
Note that during the corresponding calibration sweep the R&S ZNB/ZNBT expects the
physical port connections to be established exactly as specified by the created port
assignments.
SCPI Command Reference
To Next Page
Loading...
