GUI Reference
R&S
®
ZNB/ZNBT
274User Manual 1173.9163.02 ─ 53
Use the Smith chart to obtain an alternative, graphical representation of the converted
impedances in a reflection measurement.
Tip: Use the "Y- Z-Params" tab to measure Y-parameters including the transfer param-
eters.
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "Y-S11" |
"Y-S12" | "Y-S21" | "Y-S22"
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "Y-S11" |
"Y-S12" | "Y-S21" | "Y-S22"
Balanced Ports...
Opens a dialog to configure the logical ports of the analyzer.
See Chapter 6.2.1.3, "Balanced Ports Dialog", on page 256.
6.2.7 Y-Z-Params Tab
Allows you to select Y- and Z-parameters as measured quantities. Both Y- and Z-
parameters can serve as an alternative to S-parameters for characterizing a linear n-
port network.
Background information
Refer to the following sections:
●
Chapter 5.3.3, "Impedance Parameters", on page 120
●
Chapter 5.3.4, "Admittance Parameters", on page 124
●
Chapter 5.3.3.2, "Z-Parameters", on page 123
●
Chapter 5.3.4.2, "Y-Parameters", on page 124
Y/Z-Parameter
Selects an Y-parameter or Z-parameter as a measured quantity for the active trace.
For an n-port vector network analyzer, the pull-down list provides the full set of n
2
Y-
and Z-parameters.
Meas Softtool
To Next Page
Loading...
