Rohde & Schwarz R&S ZNB - Format Softtool

GUI Reference
R&S
®
ZNB/ZNBT
284User Manual 1173.9163.02 ─ 53
Range DC
Select the DC range of each DC INPUT connector in use according to the (estimated)
input voltage range; see "DC 1/DC 2/DC 3/DC 4/Source Port" on page 281.
Remote command:
[SENSe<Ch>:]DC<DCInp>:RANGe
6.3 Format Softtool
The "Format" softtool allows you to define how the measured data is presented in the
diagram area.
Access: TRACE – [FORMAT]
Measured quantities and display formats
The analyzer allows arbitrary combinations of display formats and measured quantities
(see Chapter 6.2, "Meas Softtool", on page 251). Nevertheless, to extract useful infor-
mation from the data, it is important to select a display format which is appropriate to
the analysis of a particular measured quantity.
An extended range of formats is available for markers. To convert any point on a trace,
create a marker and select the appropriate marker format (see "Marker Format"
on page 366). Marker and trace formats can be applied independently.
Background information
Refer to the following sections:
●
Chapter 5.2.3, "Trace Formats", on page 107
●
Chapter 5.2.3.3, "Measured Quantities and Trace Formats", on page 115
Format Softtool