Rohde & Schwarz R&S ZNB - Imbal. CMRR Tab

GUI Reference
R&S
®
ZNB/ZNBT
276User Manual 1173.9163.02 ─ 53
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "Z11" | "Z12" |
"Z21" | "Z22"
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "Z11" | "Z12" |
"Z21" | "Z22"
Balanced Ports...
Opens a dialog to define a balanced port configuration.
See Balanced Ports Dialog.
6.2.8 Imbal. CMRR Tab
Selects an imbalance or common mode rejection ratio (CMRR) as measured quantity.
The "Imbal. CMRR" measurements require at least two logical ports are available, at
least one of them balanced.
Background information
Refer to the following sections:
●
Chapter 5.3.6, "Unbalance-Balance Conversion", on page 128
●
Chapter 5.3.6.3, "Imbalance and Common Mode Rejection", on page 131
6.2.8.1 Controls on the Imbal. CMRR Tab
The following buttons in the "Imbal. CMRR" tab open additional dialogs:
●
"Imbalance Differential...": see Chapter 6.2.8.2, "Imbalance Differential Dialog",
on page 277.
This button is only enabled, if a balanced and two single-ended logical ports are
available.
Meas Softtool