Rohde & Schwarz R&S ZNB - External Devices Tab

GUI Reference
R&S
®
ZNB/ZNBT
690User Manual 1173.9163.02 ─ 53
Remote command:
SYSTem:COMMunicate:GPIB[:SELF]:INIT:WAIT
SYSTem:COMMunicate:GPIB[:SELF]:LPORt:ALIGn
SYSTem:COMMunicate:GPIB[:SELF]:DCLear:SUPPress
Instrument Messages...
Opens the System Configuration dialog with the Messages Tab selected. From there
you can configure the display of instrument messages as information popups, in partic-
ular the display of remote control command errors.
6.17.4 External Devices Tab
Allows you to set up and configure external power meters, generators and calibration
units and to enable error logging for the current session.
Background information
Refer to the following sections:
●
Chapter 5.7.20, "External Power Meters", on page 237
●
Chapter 5.7.21, "External Generators", on page 239
●
Chapter 5.5.5, "Automatic Calibration", on page 167
6.17.4.1 Controls on the External Devices Tab
Setup Softtool