Rohde & Schwarz R&S ZNB - Page 691

GUI Reference
R&S
®
ZNB/ZNBT
691User Manual 1173.9163.02 ─ 53
The buttons in the "External Devices" panel open the following dialogs:
●
"Power Meters...", see Chapter 6.17.4.2, "External Power Meters Dialog",
on page 691
●
"Power Meter Config...", see Chapter 6.17.4.3, "External Power Meter Config Dia-
log", on page 695
This button is active only if at least one external power meter is online (physically
connected, switched on, ready to be used).
●
"Generators...", see Chapter 6.17.4.4, "External Generators Dialog", on page 696
Switch matrices can be configured on the "External Ports" tab, see Chapter 6.17.5.3,
"External Matrices Dialog", on page 701 and Chapter 6.17.5.5, "Switch Matrix RF
Connections Dialog", on page 706.
Remote control via GPIB
To control external devices via GPIB, you have to use an Chapter 5.7.19, "USB-to-IEC/
IEEE Adapter", on page 237.
Log Errors
Enables the transfer of error messages for external devices (e.g. connection errors) to
the error log. The error log appears in the "Info" dialog; see Chapter 6.17.1.3, "Info Dia-
log", on page 683.
Remote command:
n/a
6.17.4.2 External Power Meters Dialog
The "External Power Meters" dialog configures external power meters so that they can
be used for measurements and power calibrations.
Access: SYSTEM – [SETUP] > "External Devices" > "Power Meters..."
Background information
Refer to section Chapter 5.7.20, "External Power Meters", on page 237.
Setup Softtool