GUI Reference
R&S
®
ZNB/ZNBT
326User Manual 1173.9163.02 ─ 53
Export to File... ← Contents
Opens a dialog that allows to export the (filtered) content of the fault list to an ASCII file
with configurable "Field Separator" and "Decimal Separator".
This CSV type file contains one line (terminated by CR+LF) per fault. With ";" as "Field
Separator" and "." as "Decimal Separator", the fault list of Figure 6-3 is exported to
1; Trc1; 457.2 mm; -8.56 dB
2; Trc1; 1.539 m; -9.24 dB
For an explanation of the possible filters, see "Contents" on page 325).
Tracking Enabled
If checked (default), the "Fault Table" on page 325 is cleared at every sweep start and
populated in real time. Uncheck "Tracking Enabled" to freeze the table contents.
6.5.8 Trace Statistics Tab
Evaluates statistical and phase information of the entire trace or of a specific evalua-
tion range and calculates the x-dB compression point.
Trace Config Softtool
To Next Page
Loading...
