Rohde & Schwarz R&S ZNB - Cal Softtool

GUI Reference
R&S
®
ZNB/ZNBT
415User Manual 1173.9163.02 ─ 53
Related information
Refer to Chapter 5.1.4, "Sweep Control", on page 83.
Sweep All Channels
Apply the sweep control settings to all channels in the active recall set. The number of
sweeps in a "Single" sweep sequence is equal to the selected number of "Sweeps"
times the number of channels. The sequence starts with the first sweep in channel no.
1.
Tip: In remote control, it is possible to retrieve the results acquired in any of the
sweeps within a single sweep group.
Remote command:
INITiate<Ch>[:IMMediate]:SCOPe ALL
[SENSe<Ch>:]SWEep:COUNt
Sweep Active Channel
Apply the sweep control settings to the active channel only. The number of sweeps in a
"Single" sweep sequence is equal to the number of "Sweeps" in the active channel.
The table lists all channels in the active recall set and allows you to define individual
numbers of sweeps for all channels. When a new channel is selected, the analyzer
uses its specific number of sweeps.
Remote command:
INITiate<Ch>[:IMMediate]:SCOPe SINGle
[SENSe<Ch>:]SWEep:COUNt
6.11 Cal Softtool
The "Cal" softtool provides all functions related to system error calibration, scalar
power calibration, and "SMARTerCal".
Access: CHANNEL – [CAL]
Cal Softtool