GUI Reference
R&S
®
ZNB/ZNBT
593User Manual 1173.9163.02 ─ 53
Adjust Impedance Mismatch
If checked, the SFD tool performs automatic impedance adjustments.
Remote command:
CALCulate:FMODel:SFD<Ph_pt>:AUTO on page 804
6.13.6 Port Sets Tab
Selects transformation networks for deembedding/embedding arbitrary port sets,
defines their parameters, assigns them to a port set and enables embedding.
Use the complementary dock widget to create the required port sets and to activate or
deactivate dembedding/embedding for selected port sets (see Chapter 6.13.1.4, "Port
Sets Panel", on page 565).
Background information
Refer to Chapter 5.6.2.5, "Port Pair De-/Embedding", on page 194 and Chap-
ter 5.6.2.6, "Port Set De-/Embedding", on page 195.
If the "Fixture Simulator" is disabled for the related channel (see "Fixture Simulator"
on page 506), this tab is inactive, i.e. all controls except the "Overview" button are
grayed out.
Overview
See "Overview" on page 572.
Type
Switches between "Deembedding" and "Embedding" network definition.
Offset Embed Softtool
To Next Page
Loading...
