Rohde & Schwarz R&S ZNB - Calculate<Chn>:Marker:mpeak:excursion:state

Command Reference
R&S
®
ZNB/ZNBT
830User Manual 1173.9163.02 ─ 53
Parameters:
<OutFormat> DEFault | MLINear | MLOGarithmic | MDB | PHASe | POLar |
COMPlex | GDELay | REAL | IMAGinary | SWR | LINPhase |
MLPHase | LOGPhase | MDPHase | IMPedance | ADMittance |
MIMPedance
DEFault means the default marker format is dynamically adjus-
ted to the selected trace format (CALCulate<Chn>:FORMat).
For the other marker formats see the table below and the
description in "Marker Format" on page 98.
*RST: DEFault
Manual operation: See "Dflt Marker Frmt" on page 290
SCPI GUI
MLINear Lin Mag
MLOGarithmic
MDB (for R&S ZVR compatibility)
dB Mag
PHASe Phase
POLar
COMPlex (for R&S ZVR compatibility)
Real Imag
GDELay Delay
REAL Real
IMAGinary Imag
SWR SWR
LINPhase
MLPhase (for R&S ZVR compatibility)
Lin Mag Phase
LOGPhase
MDPhase (for R&S ZVR compatibility)
dB Mag Phase
IMPedance R + j X
ADMittance G + j B
MIMPedance IMP Mag
CALCulate<Chn>:MARKer:MPEak:EXCursion <TargetSearchVal>
Defines a minimum excursion value for multiple peak searches.
Use CALCulate<Chn>:MARKer:MPEak:EXCursion:STATe to activate it.
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI Command Reference