Rohde & Schwarz R&S ZNB - Intermod. Tab

GUI Reference
R&S
®
ZNB/ZNBT
539User Manual 1173.9163.02 ─ 53
6.12.4 Intermod. Tab
Controls the intermodulation measurement including power calibration. The intermodu-
lation measurement requires options R&S ZNB/ZNBT-K4 and R&S ZNB/ZNBT-K14.
The results can be selected using the "Intermod." tab of the "Meas" softtool, see Chap-
ter 6.2.4, "Intermod. Tab", on page 267.
The Intermodulation Presetting Wizard guides through the measurement configuration.
Background information
Refer to Chapter 5.7.4.3, "Intermodulation Measurements", on page 222.
6.12.4.1 Controls on the Intermod Tab
The buttons on the "Intermod" tab open the following dialogs:
●
"Intermod Wizard...": See Chapter 6.12.4.2, "Intermodulation Presetting Wizard",
on page 541
●
"Define Intermod...": See Chapter 6.12.4.3, "Define Intermodulation Distortion
Measurement Dialog", on page 545
●
"Frequencies Powers...": See Chapter 6.12.4.4, "Frequencies and Power Dialog",
on page 548
●
"Generators...".: See Chapter 6.17.4.4, "External Generators Dialog",
on page 696
●
"Intermod Pwr Cal...": See Chapter 6.12.4.5, "Intermod. Pwr. Cal Wizard",
on page 549
Channel Config Softtool