Rohde & Schwarz R&S ZNB - Page 696

GUI Reference
R&S
®
ZNB/ZNBT
696User Manual 1173.9163.02 ─ 53
Deembed Two-Port (All Channels)
Reads and modifies the state of the built-in S-parameter correction that is available on
certain R&S®NRP-Z power sensors. See Application Note 1GP70 "Using S-Parame-
ters with R&S®NRP-Z Power Sensors" for background information. This Application
Note is available on the Rohde & Schwarz internet at http://www.rohde-schwarz.com/
appnotes/1GP70.
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:SPCorrection[:STATe]
6.17.4.4 External Generators Dialog
The "External Generators" dialog configures external generators so that they can be
used for measurements and power calibrations.
Access: SYSTEM – [SETUP] > "External Devices" > "Generators..."
Background information
Refer to section Chapter 5.7.21, "External Generators", on page 239.
The configuration of a new external generator involves the following steps:
1. Connect the generator to your R&S ZNB/ZNBT using a LAN (VXI-11), GPIB, or
USB interface.
2. If the generator is connected via LAN, enable "LAN detection"
3. Click "Scan Instruments" and wait until the generator appears in the table of
"Known Devices".
4.
Click
to copy the generator into the list of configured devices.
Setup Softtool