Command Reference
R&S
®
ZNB/ZNBT
1140User Manual 1173.9163.02 ─ 53
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DELete:ALL
Deletes all port assignments (see Chapter 5.5.5.4, "Multiple Port Assignments",
on page 172).
Suffix:
<Ch>
.
Channel number of the calibrated channel
Example: See [SENSe<Ch>:]CORRection:COLLect:AUTO:
ASSignment<Asg>:DEFine
Usage: Event
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment<Asg>:ACQuire
Starts the automatic calibration sweep for the indicated channel and port assignment.
A complete, valid set of port assignments must be defined before you can initiate a cal-
ibration. See Chapter 5.5.5.4, "Multiple Port Assignments", on page 172 for back-
ground information.
Suffix:
<Ch>
.
Number of the calibrated channel
<Asg> Number of the port assignment
Example: See [SENSe<Ch>:]CORRection:COLLect:AUTO:
ASSignment<Asg>:DEFine
Usage: Event
Manual operation: See "Start Cal Sweep / Abort Sweep" on page 426
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment<Asg>:DEFine
<TestPort1>, <CalUnitPort1>, <TestPort2>...
Manually defines port assignment no. <Asg> for channel no. <Ch>.
With manual configuration a non-minimal set of port assignments can be created,
which may increase measurement accuracy. On the other hand, it is up to the user to
ensure that the created set of port assignments is complete and valid for the chosen
calibration type (see [SENSe<Ch>:]CORRection:COLLect:AUTO:CONFigure).
Note that during the corresponding calibration sweep the R&S ZNB/ZNBT expects the
physical port connections to be established exactly as defined by the port pairs.
Use
●
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment<Asg>:DEFine:
TPORt command to take advantage of auto-detection of port connections.
●
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:DEFault
or [SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:
TPORt:DEFault to create the default assignments instead.
SCPI Command Reference
To Next Page
Loading...
