Rohde & Schwarz R&S ZNB - Calculate<Chn>:Marker<Mk>:Excursion; Calculate<Chn>:Marker<Mk>:Excursion:state; Calculate<Chn>:Marker<Mk>:Format

Command Reference
R&S
®
ZNB/ZNBT
835User Manual 1173.9163.02 ─ 53
<Mk> Marker number
Parameters:
<Value> Minimum peak excursion
The unit is derived from the active trace format and cannot be
modified. Changing the trace format resets the excursion to a
format-specific default value.
Manual operation: See "Excursion Settings" on page 372
CALCulate<Chn>:MARKer<Mk>:EXCursion:STATe <Boolean>
Activates or deactivates the marker-specific minimum excursion for peak searches.
Use CALCulate<Chn>:MARKer<Mk>:EXCursion to set the minimum peak excur-
sion.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number
Parameters:
<Active> Boolean
Manual operation: See "Excursion Settings" on page 372
CALCulate<Chn>:MARKer<Mk>:FORMat <OutFormat>
Sets/queries the output format for the (complex) value of the related marker.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number.
Parameters:
<OutFormat> DEFault | MLINear | MLOGarithmic | MDB | PHASe | POLar |
COMPlex | GDELay | REAL | IMAGinary | SWR | LINPhase |
MLPHase | LOGPhase | MDPHase | IMPedance | ADMittance |
MIMPedance
DEFault means that the marker is formatted according to the
related trace's default marker format (see CALCulate<Chn>:
MARKer:DEFault:FORMat), which may not be set to DEFault
(= trace format).
For the other marker formats, see CALCulate<Chn>:MARKer:
DEFault:FORMat and the description in "Marker Format"
on page 98.
*RST:
DEFault
Manual operation: See "Marker Format" on page 366
SCPI Command Reference