Rohde & Schwarz R&S ZNB - Working with Dialogs

Getting Started
R&S
®
ZNB/ZNBT
57User Manual 1173.9163.02 ─ 53
●
the "EXT REF" symbol, if an external reference clock is used for synchronization
(see "Ext Frequency" on page 687)
●
a symbol for redefined S-parameters, if the physical ports have been redefined
(see Chapter 6.17.5.2, "Define Physical Ports Dialog", on page 701)
●
A flashing green LXI status symbol indicates that a LAN connection has been
established; a red symbol indicates that no LAN cable is connected.
●
the switch matrix status symbol, if a switch matrix is configured
(See Chapter 5.7.22, "External Switch Matrices", on page 241)
●
the current date and time
Figure 4-8: R&S ZNB/ZNBT with redefined physical ports
Figure 4-9: R&S ZNB/ZNBT with switch matrix
The progress bar shows a moving color gradient if the current sweep is too fast to be
monitored, e.g. because the number of sweep points is low. You can hide/show the sta-
tus bar using SYSTEM – [DISPLAY] > "View Bar" > "Status Bar".
4.3.3 Working with Dialogs
Dialogs provide groups of related settings and allow to make selections and enter data
in an organized way. The settings are visualized, if possible. An example is shown
below.
Operating the Instrument