Rohde & Schwarz R&S ZNB - Calculate:limit:circle:fail:all; Calculate:limit:fail:all

Command Reference
R&S
®
ZNB/ZNBT
811User Manual 1173.9163.02 ─ 53
CALCulate<Chn>:LIMit:SEGMent<Seg>:INTerpol............................................................. 823
CALCulate<Chn>:LIMit:SEGMent<Seg>:STIMulus:STARt..................................................824
CALCulate<Chn>:LIMit:SEGMent<Seg>:STIMulus:STOP.................................................. 824
CALCulate<Chn>:LIMit:SEGMent<Seg>:TYPE................................................................. 824
CALCulate<Chn>:LIMit:SOUNd[:STATe]...........................................................................825
CALCulate<Chn>:LIMit:STATe.........................................................................................825
CALCulate<Chn>:LIMit:STATe:AREA............................................................................... 826
CALCulate<Chn>:LIMit:TTLout<Pt>[:STATe].....................................................................826
CALCulate:LIMit:CIRCle:FAIL:ALL? [<RecallSet>]
Returns a 0 or 1 to indicate whether or not the circle limit check has failed for at least
one channel in the referenced recall set. 0 represents pass and 1 represents fail
Query parameters:
<RecallSet> Recall set name; if omitted the active recall set is used
Usage: Query only
Manual operation: See "Limit Check" on page 358
CALCulate:LIMit:FAIL:ALL? [<RecallSet>]
Returns a 0 or 1 to indicate whether or not the limit line check has failed for at least
one channel in the referenced recall set. 0 represents pass and 1 represents fail.
Query parameters:
<RecallSet> Recall set name; if omitted the active recall set is used
Usage: Query only
Manual operation: See "Limit Check" on page 345
CALCulate:LIMit:FAIL:DATA? <TraceName>, <LimitFailType>
Returns those sweep points that have caused a limit violation of the given <LimitFail-
Type> for trace <TraceName>.
Query parameters:
<TraceName> Trace name, uniquely identifying the related trace
<LimitFailType> LIMit | RIPPle | CIRCle
Limit (fail) type
Usage: Query only
CALCulate<Chn>:LIMit:CIRCle[:STATe] <Boolean>
Switches the circle limit check on or off.
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI Command Reference