Rohde & Schwarz R&S ZNB - Page 98

Concepts and Features
R&S
®
ZNB/ZNBT
98User Manual 1173.9163.02 ─ 53
Info Table
If you wish to reserve the full diagram space for traces, you can drag & drop the
marker info field to the info table.
The info table is hidden by default. To display it, open the "Display" softtool (SYSTEM –
[DISPLAY]), activate its "Config" tab and select "Info Table" – "Show".
Marker Format
Marker values can be formatted according to the current trace format, according to the
default marker format of the related trace (TRACE > [FORMAT] > "Format" > "Dflt
Marker Frmt"), or formatted individually (TRACE > [MARKER] > "Marker Props" >
"Marker Format").
The available marker formats are defined for all measured quantities and trace formats
(see Chapter 5.2.3.3, "Measured Quantities and Trace Formats", on page 115).
Essentially, a marker format is simply a conversion between points on a complex-val-
ued trace (the raw measurement data) and the respective target format. This must be
kept in mind when interpreting the results and physical units displayed.
The following table describes how a complex marker value z = x + jy is converted. It
makes use of the polar representation z = x + jy = |z| e
jφ(z)
, where
|z| = ( x
2
+ y
2
)
1/2
and φ(z) = arctan( y / x )
Table 5-2: Marker formats
Marker Format Description Formula
Default
●
For an individual marker, this means that
the marker is formatted according to the
default marker format of the related trace.
●
For a trace's default marker format, this
means that the default format is (dynamically)
adjusted according to the selected trace for-
mat.
–
Lin Mag Magnitude of z, unconverted
|z| = sqrt ( x
2
+ y
2
)
dB Mag Magnitude of z in dB
|z| = sqrt ( x
2
+ y
2
) dB Mag(z) =
20 * log|z| dB
Phase Phase of z φ (z) = arctan (y/x)
Delay Group delay, neg. derivative of the phase
response
*)
– dφ(z) / dω, where ω denotes
the stimulus frequency
Real Real part of z Re(z) = x
Imag Imaginary part of z Im(z) = y
SWR (Voltage) Standing Wave Ratio SWR = (1 + |z|) / (1 – |z|)
dB Mag Phase Magnitude of z in dB and phase in two lines 20 * log|z| dB arctan ( Im(z) /
Re(z) )
Screen Elements