GUI Reference
R&S
®
ZNB/ZNBT
414User Manual 1173.9163.02 ─ 53
These actions are only available for the DEFAULT Remote Language). For other
remote languages (compatibility modes), you can use the Restart Manager Dialog
instead.
Remote command:
INITiate:CONTinuous:ALL
Sweep Controller
Activates/deactivates the (resizable) "Sweep Info" dialog, which displays the current
sweep stage. The "Sweep Info" dialog is particularly useful for long duration sweeps
that are executed in single sweep mode: by observing the dialog, it is easy to realize
when the sweep is done.
The possible sweep stages and how they are displayed partly depend on the selected
sweep mode (see "Continuous / Single" on page 413):
Sweep Stage Sweep Controller Display
in "Continuous" Sweep
Mode
in "Single" Sweep Mode
No ongoing sweep Idle Idle
Sweep is being prepared Preparing Preparing
Ongoing sweep
1)
Continuous Sweeping
if #Sweeps = 1
Sweeping m/n
if n = #Sweeps > 1
Measurement results are being calculated Continuous Calculation Calculation
1)
The VNA is sweeping or waits for a trigger signal.
6.10.4.2 Restart Manager Dialog
The "Restart Manager" dialog defines whether the active sweep mode ("Continuous" or
"Single") and the "Sweeps" value are valid for all channels in the active recall set or for
the active channel only.
Access: CHANNEL – [SWEEP] > "Sweep Control" > "Restart Manager..."
This dialog is relevant / accessible in compatibility modes only (see "Remote Lan-
guage" on page 688).
Sweep Softtool
To Next Page
Loading...
