Rohde & Schwarz R&S ZNB - Page 525

GUI Reference
R&S
®
ZNB/ZNBT
525User Manual 1173.9163.02 ─ 53
The control elements in the "Modify Cal Power" dialog are described in the following
sections:
●
"Channel Base Power" on page 494
●
"Port Power Offset" on page 494
●
"Cal Power Offset" on page 494
Receiver Level Tab
Provides access to the receiver step attenuator settings.
Receiver step attenuators are optional hardware (see Chapter 5.7.17, "Receiver Step
Attenuators", on page 233).
Attenuation
Sets the attenuation at the respective measurement receiver (b-wave). See "Step
Attenuators" on page 387.
Remote command:
[SENSe<Ch>:]POWer:ATTenuation
Channel Config Softtool