Rohde & Schwarz R&S ZNB - Page 583

GUI Reference
R&S
®
ZNB/ZNBT
583User Manual 1173.9163.02 ─ 53
Figure 6-54: Fixture Modeling Dialog: ISD - Balanced Ports
The dialogs for the available tools only differ in the available coupon types.
The fixture modeling proceeds in the following steps:
1. Measure one or more test coupons for the related fixture; see Chapter 6.13.5.2,
"Measure Coupon", on page 584
2. Measure the DUT with the fixture; see Chapter 6.13.5.3, "Measure DUT + Test Fix-
ture", on page 586
3. Run the selected third-party tool to calculate the Touchstone files modeling the test
fixture; see Chapter 6.13.5.4, "Save Fixture Model", on page 587.
The calculated sNp file(s) can then be used to deembed the DUT at selected
port(s).
All files generated by actions in this dialog are stored in the directory C:\Users\Public
\Documents\Rohde-Schwarz\Vna\Embedding.
The current implementation assumes symmetrical lead-ins and lead-outs.
6.13.5.1 Common Controls on the Dialog
The following controls are located at the bottom of each dialog (ISD/SFD, single-
ended/balanced):
Offset Embed Softtool