Rohde & Schwarz SMIQ02B - Menu IS-95 CDMA Standard - Reverse Link Signal with Channel Coding

Digital Standard IS-95 CDMA SMIQ
1125.5555.03 E-92.148
2.12.6 Menu IS-95 CDMA Standard - Reverse Link Signal with
Channel Coding
Menu DIGITAL STD - IS-95 provides access to settings for generating IS-95 CDMA signals. The
following figure shows the menu for generating a reverse link signals with channel coding. The section
on the menu for forward link signal generation shows the parameters that are identical for both modes.
Menu selection: DIGITAL STD - IS-95- MODE - REV_LINK_CODED
FREQ
100. 000 000 0
MHz
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
IS95
PHS
IS95
NADC
PDC
GSM
L
OFF ON
MODE... REV_LINK
SET DEFAULT
MODULATION... QPSK IS-95
TRIGGER MODE... AUTO
EXECUTE TRIGGER
TRIGGER... INT
CLOCK... INT
CHANNEL TYPE/RATE TRAFFIC 14400
DATA CURRENT: PN9
ADD FRAME QUAL INDICATOR OFF ON
CONVOLUTIONAL ENCODER OFF ON
BLOCK INTERLEAVER OFF ON
ERASURE BIT 0 1
-----------------CHANGE DATA------------------
SELECT DATA LIST... CURRENT: R&STDM
COPY CURRENT DATA LIST TO...
DELETE DATA LIST...
EDIT DATA LIST...
EVEL
-30.0
dBm
PEP
- 23.3
dBm
STATE
Fig. 2-87 Menu DIGITAL STD - IS-95 - MODE - REV_LINK_CODED
Parameter STATE to CLOCK... see section "Menu IS-95 CDMA Standard - Forward Link Signal".