SMIQ Fitting the Options
1125.5555.03 E-71.15
Connector
The clock and data signals output by the DUT must have TTL level and are connected to the BER (bit error
rate) input, a 9-contact SUB-D connector at the rear of the unit labelled BER. Pin assignment is as follows:
SUB-D connector Adapter cable
Order No. 1110.3551.00
1,2,3,4,5 Ground Screen
6 Bit clock input CLOCK
7 Data input DATA
8 Data enable input DAT ENAB
9Restart RES
Polarity of clock and data signals, the PRBS polynomial used and the integration time can be set by
manual or remote-control commands. The input signals are not terminated in the SMIQ but applied to
ICs of type 74LVT14 via a 220 Ω resistor. A cable is supplied with the option. Its contacts are assigned
to BNC connectors as shown in the above table.
1.3.12 Other Software Options
SMIQB42 / SMIQB43 / SMIQB45 / SMIQB47 / SMIQB48 / SMIQB49 /
SMIQB60 / SMIQK11 / SMIQK12
You have acquired a software option to go with your Signal Generator SMIQ from Rohde & Schwarz.
This option must be enabled by an installation keyword. Please affix the enclosed option label including
the installation keyword to the rear panel of the SMIQ since it is required for service and repair. For
installation of software option SMIQB21 cf. section 1.3.11.
Enclosed option label with a typical keyword:
OPTION SMIQ-B43
DIGITAL STANDARD
W-CDMA
1104.8032.02
INSTALLATION KEY
9 5 4 8 7 6
MADE IN GERMANY
<== Example
For a sucessful installation the necessary hardware options as well as the firmware version are listed in
the following table. The firmware version is indicated in the right part of the display when only the main
menu appears. If your instrument is equipped with an older version, update the firmware first. Disks,
cables and update instructions are provided with the package.
Option Necessary hardware/software options Firmware version
(at least)
Remark
SMIQB10 (MCOD) and SMIQB11 (DGEN) 3.20SMIQB42
SMIQB20 (MCOD2) and SMIQB11 (DGEN) 5.10 HX
SMIQB10 (MCOD) and SMIQB11 (DGEN) 3.80SMIQB43
SMIQB20 (MCOD2) and SMIQB11 (DGEN) 5.10 HX
SMIQB45 SMIQB20 (MCOD2) and SMIQB11 (DGEN) 5.10 HX
SMIQB47 IQ modulator (IQMOD) variant 8 3.91
SMIQB48 SMIQB20 (MCOD2), SMIQB11 (DGEN) and SMIQB45 5.30 HX
SMIQB49 SMIQB14 and /or SMIQB15 (FSIM) 5.40 HX
SMIQB60 SMIQB20 (MCOD2) and SMIQB11 (DGEN) 5.20 HX PC software WinIQSIM
recommended
SMIQK11 SMIQB60 5.20 HX
SMIQK12 SMIQB60 5.20 HX
PC software WinIQSIM
recommended
To Next Page
Loading...
