Rohde & Schwarz SMIQ02B - ARB MOD - TRIGGER Menu

SMIQ Arbitrary Waveform Generator ARB
1125.5555.03 2.347 E-9
2.21.2.1 ARB MOD - TRIGGER Menu
Fig. 2-219 ARB MOD - TRIGGER... menu
TRIGGER...
Opens a window for setting the trigger facilities and the trigger outputs.
TRIGGER SOURCE
Configuration of trigger source.
INT Manually via EXECUTE TRIGGER or via software.
IEC/IEEE bus command
:ARB:TRIG:SOUR INT
EXT
Triggering with active edge at input socket.
IEC/IEEE bus command
:ARB:TRIG:SOUR EXT
EXT TRIGGER DELAY
Delays the start of sequence by the indicated samples
after occurrence of an external trigger event. The
resolution is 2 samples with clock rates (CLOCK) above
20 MHz (otherwise, 1 sample).
IEC/IEEE bus command
:ARB:TRIG:DEL 234
EXT RETRIGGER INHIBIT
Retriggering is inhibited until the sequence has reached the
indicated sample.
IEC/IEEE bus command
:ARB:TRIG:INH 345
TRIGGER OUT1(2) POL
Signal polarity at the trigger outputs.
POS active state: positive voltage
IEC/IEEE bus command
:ARB:TRIG:OUTP1:POL POS
NEG
active state: 0 or lower voltage
IEC/IEEE bus command
:ARB:TRIG:OUTP2:POL NEG
TRIGGER OUT1(2) DELAY
Delay of the supplied trigger signals by the set number of
samples.
IEC/IEEE bus command
:ARB:TRIG:OUTP:DEL 765