Digital Standard 3GPP W-CDMA (FDD) SMIQ
1125.5555.03 E-92.184
Fig. 2-107 DIGITAL STD - WCDMA/3GPP - Downlink - COPY BS(MS) menu
COPY BS(MS)...
Using COPY BS (MS) it is easy to create a new base/mobile station from an
existing station. This feature is useful, say, when base stations with more than
128 data channels are to be simulated. For examples, see section 2.14.3.6.2.
SOURCE BS/MS For selecting the BS(MS) whose parameter set is to be
copied. Possible values are 1, 2, 3 or 4.
IEC/IEEE-bus command :SOUR:W3GP:COPY:SOUR 1
DESTINATION For selecting the destination BS(MS) whose parameter
BS/MS set is to be overwritten. Possible values are 1, 2, 3 or 4.
IEC/IEEE-bus command :SOUR:W3GP:COPY:DEST 2
CHANNELIZATION
CODE OFFSET Offset used for the spreading codes during copying from
the source BS to the channelization codes. The
minimum value is 0 and the maximum value 511. This
parameter is only available in the downlink.
IEC/IEEE-bus command :SOUR:W3GP:COPY:COFF 123
EXECUTE
Starts copying.
IEC/IEEE-bus command :SOUR:W3GP:COPY:EXEC
TRIGGER MODE
Configuration of W-CDMA sequence control (see section 2.14.2.11).
AUTO The calculated W-CDMA chip sequence is immediately
output and repeated cyclically. Trigger events are ignored.
IEC/IEEE-bus command :SOUR:W3GP:SEQ AUTO
RETRIG The calculated W-CDMA chip sequence is immediately
output and repeated cyclically. A trigger event causes a
restart from frame 1.
IEC/IEEE-bus command :SOUR:W3GP:SEQ RETR
ARMED_AUTO Only a trigger event results in the W-CDMA chip sequence
being started from frame 1. Other trigger events are
ignored.
IEC/IEEE-bus command :SOUR:W3GP:SEQ AAUT
ARMED_RETRIG Only a trigger event results in the W-CDMA chip sequence
being started from frame 1. Each further trigger event
causes a restart.
IEC/IEEE-bus command :SOUR:W3GP:SEQ ARET
To Next Page
Loading...
