Enhanced Functions For Digital Standard 3GPP W-CDMA (FDD) SMIQ
1125.5555.03 2.258 E-9
OCNS CHANNELS
TOTAL POWER
Fraction of power of OCNS channel signal component at the overall signal
normalized to 0 dB. This menu parameter is only effective after pressing
EXECUTE ►.
IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:POW –10.0
P-CCPCH STATE
Switch with which the P-CCPCH can be added to the OCNS dedicated
channels. This menu parameter is only effective after pressing EXECUTE ►.
IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:PCCP:STAT ON
P-CCPCH POWER
Fraction of power of P-CCPCH signal component at the overall signal
normalized to 0 dB. This menu parameter is only effective after pressing
EXECUTE ►.
IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:PCCP:POW –10.0
ENHANCED CH.
TOTAL POWER
Fraction of power of enhanced channel signal component at the overall signal
normalized to 0 dB. The value for ENHANCED CH. TOTAL POWER is
determined from the POWER START values of all activated enhanced
channels and offered to the user as default value. If the user changes this
value, also the values for POWER START of the activated enhanced
channels are adapted. If all enhanced channels are inactive, ENHANCED CH.
TOTAL POWER are set to –60.0 dB.
This menu parameter is only effective after pressing EXECUTE ".
IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:EPOW –10.0
EXECUTE ►
The EXECUTE command is used to validate the settings described above and
to fill in the channel tables of the base stations.
The rules for filling in the channel tables correspond to those of the
PARA.PREDEF SETTING... menu parameter with the following exceptions:
The first 4 DPCHs are reserved for the enhanced channels. The OCNS
channel settings are entered from the 5th DPCH in the channel table. The
maximum number of DPCHs (= OCNS channels) is reduced by 4 (= number
of enhanced channels).
S-CCPCH is switched off (STATE = OFF).
The channel power values of OCNS channels must be determined from menu
parameters NUMBER OF OCNS CHANNELS and OCNS CHANNELS TOTAL
POWER. The P-CCPCH channel power is taken over from P-CCPCH POWER
menu parameter (if P-CCPCH is switched on) .
IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:EXEC
To Next Page
Loading...
