Digital Standard PDC SMIQ
1125.5555.03 2.300 E-9
(SELECT SLOT...)
VOX
(UPLINK ONLY)
SYNC2
Input value for the 20 bit sync word in the first slot of a
superframe in hexadecimal form. This sync word marks the
beginning of a superframe. The input field is only displayed if
SUPERFRAME is switched on. Depending on the selected
slot, the following sync words are predefined according to the
PDC standard:
Slot No. VOX Sync2 Word
0 CE450
1 E1A90
2 18ED3
3 043E0
4 7D861
IEC/IEEE-bus command :SOUR:PDC:SLOT2:SYNC E1A91
CC
Input value of the 8 bit data field " Color code ".
IEC/IEEE-bus command
:SOUR:PDC:SLOT2:CCOD #HFF
SF
Input value of the data field " Steal Flag ".
IEC/IEEE-bus command
:SOUR:PDC:SLOT2:SF #H0
SACCH
Selection of data source for SACCH field (Slow Associated
Control Channel).
PN.. PRBS data according to CCITT with periods
between 2
9
-1 and 2
23
-1.
IEC/IEEE
:SOUR:PDC:SLOT3:SACC PN15
DLIST Data from a programmable data list.
IEC/IEEE
:SOUR:PDC:SLOT3:SACC DLIS
SERDATA Data from data input SER DATA.
IEC/IEEE
:SOUR:PDC:SLOT3:SACC SDAT
RCH
Selection of data source for the RCH data field. RCH data
replace SACCH data in certain slots of a superframe. The
input field is only displayed if SUPERFRAME is switched on.
PN.. PRBS data according to CCITT with periods
between 2
9
-1 and 2
23
-1.
IEC/IEEE
:SOUR:PDC:SLOT3:RCH PN9
DLIST Data from a programmable data list.
IEC/IEEE
:SOUR:PDC:SLOT3:RCH DLIS
SERDATA Data from data input SER DATA.
IEC/IEEE
:SOUR:PDC:SLOT3:RCH SDAT
G2
Display of data contents in the 118 bit "Guard" field at the
end of the slot in hexadecimal form. The field is only
displayed with LINK DIRECTION = UPLINK selected.
Parameter
SELECT DATA LIST... to EDIT DATA LIST... see menu selection BURST TYPE = TCH
To Next Page
Loading...
