Digital Standard GSM/EDGE SMIQ
1125.5555.03 2.308 E-9
TRIGGER OUT 1
Selecting the signal for TRIGOUT 1 output in
PARDATA connector.
The times only apply if the default value of 270.833
ksps for GSM/EDGE is used as the symbol rate in
the Modulation menu.
SLOT 0.577 ms e.g. clock
IEC/IEEE-bus command:
:SOUR:GSM:TRIG:OUTP1 SLOT
FRAME 4.615 ms frame clock
IEC/IEEE-bus command:
:SOUR:GSM:TRIG:OUTP1 FRAM
TRIGGER OUT 2
Selecting the signal for TRIGOUT 2 output in
PARDATA connector.
The times only apply if the default value of 270.833
ksps for GSM/EDGE is used as the symbol rate in
the Modulation menu.
FRAME 4.615 ms frame clock
IEC/IEEE-bus command:
:SOUR:GSM:TRIG:OUTP2 FRAM
TRIGGER OUT 1/2
DELAY
Input value of delay of trigger signal at TRIGOUT 2
output compared with beginning of slot or frame.
IEC/IEEE-bus
SOUR:GSM:TRIG:OUTP:DEL 2
TRIGGER OUT2
PERIOD
Input value of output signal period at TRIGOUT 2
output given in frames.
IEC/IEEE-bus
SOUR:GSM:TRIG:OUTP:PER 1
TRIGGER OUT 1/2 POL
Selecting the polarity of signals at the TRIGOUT 1
and TRIGOUT 2 outputs in the PARDATA
connector.
IEC/IEEE-bus command
:SOUR:GSM:TRIG:OUTP2:POL POS
CLOCK...
Opens a window for selecting the clock source and for setting a delay.
To Next Page
Loading...
