heads may dry out and become damaged. This error may be caused by such factors as a mistake in loading
the media, a media jam, or an operation that pulls the media with excessive force.
The media has jammed
Carefully remove the jammed media. The print heads may also be damaged. Perform head cleaning, then
perform a printing test and check the results.
The media was pulled with excessive force
Excessive tension was applied to the media, and additional action is necessary to recover from this state. First,
raise the loading lever and adjust the media to create a small amount of slack, then switch on the sub power.
[PINCHROLL ERROR LOWER PINCHROLL]
This message appears when the loading lever was raised during initialization or after the
media was loaded.
The error is cleared automatically after a short wait. Load the media correctly again.
[WRONG HEAD IS INSTALLED]
An unusable print head has been installed.
Operation cannot be continued. After you switch o the sub power, contact the authorized Roland DG Corp.
dealer where you purchased the machine or Roland Corp.
[CANCELED FOR MOTOR PROTECTION]
Either of the following menu items is to be started in a row within 10 minutes:
Ink lling when purchasing this machine
PUMP UP
HEAD WASH
REFRESH SUBTANK
Press any key other than the sub power switch to cancel the error message. Allow the machine to stand for
approximately 10 minutes before resuming operation. These menu items require the pump motor to turn for
a long time. When performing these menu items in a row, take an interval of at least 10 minutes to prevent
damage to the machine due to the overheating of pump motor.
To Next Page
Loading...
