Roland Texart RT-640 - Page 21

Loading Media
2
Basic Operation
19

Loosen the securing screws of media holders.
Draw the media holders to both left and right ends respectively.

Fit the paper tube (core) of the media onto the end cap of the media holder (Left).
Do not secure the media holder now.
Move the media holder (Right) and t the end cap onto the paper tube (core) of the
media.
Fit it securely to prevent the media from moving easily.
Install conforming to the procedures.
When loading the media make sure that the media holder (Left) is drawn to the left edge. Do not
secure the media holder before loading the media. If these procedures are not followed, printing
results will be aected because the media will not be fed correctly.
Media holder (Left)
Media holder (Right)
End cap