40
When the screen on the left is displayed, open the front
cover.
Move the height-adjustment lever to adjust
the head height.
When moving to the [High] direction, the buzzer
sounds twice, and to the [Low] direction, the buzzer
sounds once.
Close the front cover.
For the individual setting method of this setting item and the description, refer to P. 91"Adjusting Print Head
Height to Match Media Thickness"
3.
Performing the position correction of feed direction (Alleviate horizontal stripes)
Press to select [Execute].
Press
to conrm.
The test pattern of feed correction is printed.
When the screen on the left is displayed, press .
Use and to set the correction value.
Press
to conrm.
*'#&*'+)*6
*+)*.19
Height-adjustment lever
Move firmly, until it stops.
High
Low
Normally set to [Low]. For media that is wrinkled
or comes loose from the platen, set to [High].
Feed direction means the feed direction of the media. Perform the correction adjusting to the media
in advance because horizontal strips are more likely to occur during printing when the movement
distance of the media changes subtly depending on the media’s type or thickness.
%#.+$4#6+10
=5'6?0':6
+0276
#&,8#.7'5
%#.+$4#6+10
Current correction value Value to be set
To Next Page
Loading...
