Controller functions
RES-445 Page 33
10.5 Two-digit numbering system
up to software revision 027
A system of one and two-digit numbers was used for
the Settings and Configuration menus up to software
revision 027. Three-digit numbers were introduced in
software revision 100 to improve the clarity of the menu
structure.
The table below compares the two numbering systems:
All number sor menu steps not listed above
are only available as of software revision 100
and are described in chap. 9 „Startup and opera-
tion“, page 19 (and section 10.4 "Menu structure"
on page 31 respectively).
The new, three-digit menu step numbers are
described first in all relevant sections of this
document. The older, two-digit numbers are indi-
cated afterwards in square brackets (e.g.
step 201 [20]).
Menu Menu steps
Numbering
up to software
revision 027
Numbering
as of software
revision 100
Settings menu Heatsealing temperature 1 101
Preheating temp. (PREHEAT) 2 102
Starting delay 3 103
Heatsealing time 4 104
Cooling value 5 105
Hold mode 6 106
AUTOCAL 7 107
Configuration menu Language 20 201
Factory settings 21 202
Alloy / TCR 22 203, 204
Maximim temperature 23 206
Set point reached 24 207
Set point exceeded 25 208
Time control 26 209
Cooling mode 27 210
Sart of heatsealing time 28 211
Relay K1 function 29 212
Cycles 30 214
Alarm relay 31 215
Measuring pulse length 32 220
Analog output 33 216
To Next Page
Loading...
