Factory settings
Page 66 RES-445
Up to software revision 027:
The controller can be reset with step 21 in the Configu-
ration menu:
The factory settings are restored if the "ENTER" key is
pressed. An acknowledgment message is displayed for
approximately 2s.
The language which is selected with step 20
in the Configuration menu remains set even if
the factory settings are restored.
Configuration menu
No. 201 [20] Language German
This selection is NOT changed if the
factory settings are restored with
step 202 [21] in the Config. menu.
No. 203, 204 [22]
Alloy/range: Alloy-20/max. 300°C
No. 206 [23] Maximum temperature: 300°C
No. 207 [24] Set point reached: -10K
No. 208 [25] Set point exceeded: +10K
No. 209 [26] Time control: OFF
No. 210 [27] Cooling mode: Absolute
No. 211 [28] Start of heatsealing time: When temperature reached
No. 212 [29] Relay K1 function: Active when temperature reached
No. 213 Lock of „HAND“ key OFF
No. 214 [30] Cycle counter: 0
No. 215 [31] Alarm relay: Normal (contact closed by a fault)
No. 216 [33] Analog output: Actual temperature
No. 217 Temperature diagnosis: OFF
No. 218 Temp.diagnosis
delay time: 0s
No. 219 Heatup timeout: OFF
No. 220 [32] Measuring impulse length:Standard (1.7ms)
No. 221 Autocomp: OFF
No. 222 "Output 1": Active if Tact = Tset, with latch function
No. 225 Temperature unit: Celsius
To Next Page
Loading...
