Reference Manual
00809-0100-4130, Rev AA
May 2009
1-5
Rosemount 2130
Examples of products that can create bridging of forks are dense paper
slurries and bitumen
• Check the solids content in the liquid
As a guideline, the maximum solid particle diameter in the liquid is
0.2 in. (5 mm)
Extra consideration is needed when dealing with particles bigger than
0.2 in. (5 mm). Consult the factory for advice.
• Problems may occur if product coats and dries causing caking.
• In almost all cases, the 2130 is insensitive to foams (i.e. does not see
the foam).
However in rare occasions, some very dense foams may be seen as
liquid; a known example of this is found in ice-cream and orange juice
manufacturing.
To Next Page
Loading...
