Royal 580 - Manager Passwords; To Set the Program Mode Manager Password; To Program the X and Z Mode Manager Passwords

MANAGER PASSWORDS
Two Manager Passwords are available as an added meas ure; one password accesses the PRG (PROGRAM), and
one accesses the "X" and "Z" modes. The Manager Password resets every time it is used, therefore once a
password has been programmed, it must be entered every time you access the program mode or before every "X"
or "Z" reading is taken.
NOTE: If the Manager Password is programmed as (0000), the machine will not acknowledge this password.
CAUTION: Please w rite y our passw ords dow n in a safe place. If the passw ords are forgotten, a FULL
SYSTEM CLEAR procedure w ill be necessary . A Full Sy stem Clear w ill erase all transaction data and
programming. For details on the Full System Clear see Page 94.
TO SET THE PROGRAM MODE MANAGER PASSWORD
"PRG" + (19) + [QTY/TIME] + (PASSWORD #) + [AMT TEND/TOTAL]
1 - 4 digit #
Example: If the Manager Password is 1212:
1. Turn the key to the "PRG" (PROGRAM) position.
2. TYPE (19), PRESS [QTY/TIME], TYPE (1212), then PRESS the [AMT TEND/TOTAL] key.
TO USE THE PROGRAM MODE MANAGER PASSWORD
"PRG" + (PASSWORD #) + [CLERK]
1 - 4 digit #
1. Turn the key to the "PRG" (Program) position.
2. Input the password and PRESS the [CLERK] key.
3. You are now ready to program.
TO PROGRAM THE X and Z MODE MANAGER PASSWORDS
"PRG" + (18) + [QTY/TIME] + (MANAGER PASSWORD #) + [AMT TEND/TOTAL]
1 - 4 digit #
Example: If the X and Z mode password is 1313:
1. Turn the key to the "PRG" (PROGRAM) position.
2. TYPE (18), PRESS [QTY/TIME], TYPE (1313), then PRESS [AMT TEND/TOTAL].
TO USE THE "X" and "Z" MANAGER PASSWORD
"X" or "Z" + (MANAGER PASSWORD #) + [CLERK]
1 - 4 digit #
Example: Access the X or Z modes, when the Manager Password is 1313:
1. Turn the key to the "X" or "Z" mode as needed.
2. TYPE (1313), then PRESS the [CLERK] key.
3. You are now ready to take any reports based on your selection in Step 1.
20