Royal 580 - Transaction Number Preset; To Program the Transaction Number

TRANSACTION NUMBER PRESET
Transaction Number Preset allows you to choose a begi nning transaction number of your own. The Transaction
Number normally begins with the number 0001 and counts up cons ecutively until a "Z" Report is taken; thereafter it
resets back to 0001. Transaction Number Preset can also be used to re-enter the last transaction number in the
event information is lost.
Extra Option: The register is programmed to have the Transac tion Number reset to zero after a "Z" Report is taken.
If desired, a procedure is offered not to have the Transaction Number reset to zero after a "Z" Report
is taken. See Flag 8, Option 5 on Page 55.
TO PROGRAM THE TRANSACTION NUMBER
"PRG" + (11) + [QTY/TIME] + (TRANSACTION #) + [AMT TEND/TOTAL]
4 digit # (in range 0-9999)
Example: To program the Transaction Number to be 1000:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. TYPE (11), PRESS [QTY/TIME], TYPE (1000), then PRESS the [AMT TEND/TOTAL] key.
39