UNPACKING YOUR CASH REGISTER and SET-UP
PREPARATION
When your cash register is new in its factory packaging, you will find the various items for the register packaged
separately. Look for and unwrap the following: 1 paper roll, black journal winder spindle and duplicate key sets for
the Control Lock and Cash Drawer/Journal Lock.
STANDARD ACCESSORIES
The following are included in the box with your cash register:
· Instruction manual.
· 1 black plastic journal winder spindle.
· 1 starter roll of standard single-ply paper tape, Ro yal Reorder Number 013129 (57mm). This model can
also use 2-ply paper rolls, Royal Reorder Number 013130 (57mm).
· 1 purple ribbon (already installed), Royal Reorder Number 013019.
· 3 standard "AA" batteries for battery back-up system.
· Keys: (2) Cash Drawer/Journal Lock Keys (515).
(2) Manager's Program Keys (MA, 33-I).
(2) Operator Register Keys (OP, 33A).
IT IS IMPORTANT THAT YOU READ THE INITIA L SET-UP AND MAINTENANCE INSTRUCTIONS BEFORE
ATTEMPTING TO OPERATE THE CASH REGISTER.
INITIAL SET UP
1. Locate on level surface - Before operating the cash register, be sure it is placed on a level surface to
permit smooth operation of the register cash drawer.
2. Insert Manager's Program Key (MA, 33-1) and turn to the "PRG" position. IMPORTANT: THIS
PROCEDURE MUST BE DONE TO INITIALIZE THE CASH REGISTER. HOLD DOWN THE CLEAR
KEY AND PLUG IN THE CASH REGISTER.
3. This cash register operates on any standard three- hole electrical outlet (115- 120 volt, 60 hertz). It is
recommended that the cash register be connected to an electrical circuit where no other electrical device
or appliance is connected which may overload the circui t or cause electrical interference with the cash
register. It is best that a single circuit be provided for register operations.
4. Install the 3 standard "AA" batteries provided. Refer to Page 10 for battery installation instructions.
5. Install paper - Refer to Page 11-12 for paper installation instructions.
MAINTENANCE OF YOUR REGISTER
· Your register must remain uncovered when tur ned on; this will allow proper cooling of electronic
components.
· Use a dust cover when the register is not in operation to protect mechanical components from dust.
· Take care to keep beverages and other liquids away from the machine to avoid spills which may damage
electronic components (use optional protective keytop cover to prevent damage to machine).
· To clean, use a soft dry cloth. Do not use harsh solutions containing alcohol.
· Your machine should be kept in areas free from dust, dampness or extreme temperatures (hot or cold).
· After storage in extreme temperatures (bel ow 32 degrees fahrenheit or above 104 degrees fahrenheit),
allow the temperature inside the machine enough time to reach room temperature before switching on.
· Never pull the paper tape through the printhead. To prevent damage, always use the electronic paper
feed key.
· Should electronic service be needed, a Royal authorized service center is recommended.
1
To Next Page
Loading...
