Z1 and Z2 COUNTER PRESET
Z1 and Z2 COUNTER PRESET
Z1: Represents the End-of-Day reading (resets totals to "0").
Z2: Represents the End-of-Week/Month reading (resets totals to "0").
Allows you to select the beginning number for the Z1 Counter. The "Z" Counter is programmed by the factory to count up
consecutively after each "Z" reading. It pr ovides a tally of the number of "Z" readi ngs from the first "Z" reading taken on the
cash register to the present. In the ev ent a Full System Clear procedure is performed (which resets all data to zero), the "Z"
Counter Preset feature will also allow you to re-enter the previous "Z" Counter Number.
TO PROGRAM THE Z1 COUNTER NUMBER
"PRG" + (14) + [QTY/TIME] + (Z1 COUNTER #) + [AMT TEND/TOTAL]
4 digit #
Example: To program the Z1 Counter for the number 0050:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS the [CLERK] key, or
if you did not program a Manager Password, go to Step 3.
3. TYPE (14), then PRESS the [QTY/TIME] key.
4. TYPE (0050), then PRESS the [AMT TEND/TOTAL] key.
TO PROGRAM THE Z2 COUNTER NUMBER
"PRG" + (15) + [QTY/TIME] + (Z2 COUNTER #) + [AMT TEND/TOTAL]
4 digit #
Example: To program the Z2 Counter for the number 0100:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS the [CLERK] key, or
if you did not program a Manager Password, go to Step 3.
3. TYPE (15), then PRESS the [QTY/TIME] key.
4. TYPE (0100), then PRESS the [AMT TEND/TOTAL] key.
41
To Next Page
Loading...
