Royal 580 - Flag Options

FLAG OPTIONS
A total of 16 system programming options (known as FLAGS) are offered on this cash register. They are preset at the
factory to accommodate the most commonly used selections. Each flag option can be changed or updated at any time as
needed.
NOTE: Most flags have been factory preset at "0". They only need to be programmed if you wish to change any option from
the default setting.
The following is a brief description of the function selection flags available, but it is not nec essary to set every one. Sele ct
only those you need.
FLAG
NUMBER DESCRIPTION
1 This flag is used to select either the receipt or journal mode; the comma or period symbol to
separate thousands; time and date display; and number of decimal places.
2 This flag is used to select the rounding method; percentages and multiplication calculations.
3 This flag allows you to select the rounding method for tax calculations.
4 This flag is used to select the print format options for the receipt and journal modes.
5 This flag is used to select the print format option for sales tax information in the journal and receipt
modes.
6 This flag is used to select "0" pricing; grand total calculation; hourly report print format; selecting
department total calculation options; and clerk ID entry restriction.
7 This flag is used to limit the use of RA, PO, VOID, CPN and NOSALE keys in the REG mode; split
tendering and compulsory tendering.
8 This flag is used to select stub receipts, duplicate receipt options; department shift, transaction
number reset, compulsory cash declaration and print position of date, time and commercial
message.
9 This flag is used to select clerk report; and clerk password entry.
10 This flag is used to select print format options for management reports.
11 This flag is used to select duplicate reports; printing font of CASH, CHARGE and CHECK; print
format options for PLU and management reports.
12 This flag is used to select Canadian Tax options.
13 This flag is not used.
14 This flag is not used.
15 This flag is used to set the number of line feeds after printing the receipt in the receipt mode.
16 This flag is used to enable/disable the keystroke sound resulting from pressing any numeric key or
function key and to determine if the cash drawer will open when finalizing a sale with the AMT
TEND/TOTAL, CHARGE or CHECK keys.
48